SAFETY RULES FOR THE USE OF MAN-MADE FIBRE SLINGS SAFETY INFORMATION MAN-MADE FIBRE SLINGS IN CHEMICAL & HEAT ENVIRONMENTS
The surface engaged by the eye should be: •
Smooth with no sharp edges. •
Of adequate radius. •
Not so wide as to tear the sewn joint apart.
Take extra care and use a sling of ample capacity: •
When the exact loading is in doubt.
When there is liability of severe shock loading.
When conditions are abnormal or severe.
When there is any hazard to life and limb.
Always protect those parts of the webbing where abrasion or cutting may occur.
Always strictly observe the following precautions (they will prolong the life of your slings):
Never cross or twist any sling.
Never throw a sling from height.
Never drag a sling over a rough surface.
Never allow a load to rest on a sling if this could damage the sling. • Never pull a sling out from under a load. • Avoid snatch or shock loading. Never overload a sling. Never use a damaged sling. Never engage a soft eye with anything that could damage it. A brief outline is given below but users should write to our technical staff for advice on their specific conditions. N.B. Thorough washing in warm water and drying after use with chemicals, even under permitted conditions, is essential to avoid degradation. ACID – At room temperature the resistance of polyester slings to many acids is satisfactory but in more severe acid conditions users are required to refer to our technical team for assistance. ALKALI – The use of polyester belt slings in strong alkali is not recommended. HEAT – The resistance to dry heat degradation is very good. However, do not use in conditions where the temperature is in excess of 100-degrees C
